Waterjet propulsion – the protective coating with MetaLine 785 elastomeric armouring protects this waterjet drive of a costal patrol boat from heavy erosion & cavitation. The photo was taken after 6 months of operation
Stevenholer coating – 2 mm MetaLine 785 is enough to protect the steven holders as well as the rudders from corrosion, erosion ans sealife settlement
Stevencoating – a sprayable heavy duty cavitation protection for the durable treatment of this steven
Anti-Fouling coating – the key question for underwater coatings: Anti-Fouling character without the use of any toxic additive within MetaLine Series 700. Elastomeric works without . . .
MetaLine 785 as a cavitation protective coating on sport boat propellers
Propeller protection – MetaLine 785 as cavitation protection on a twin propulsion system of this 80# cruiser
Propeller repairs – elastomeric coating characteristics and the marine world! A technical success story with a very special character: corrosion-free, salt resistant, impact absorbing and light weight
A 3 mm coating of MetaLine 795 as wear resistant and decorative treatment for hawseholes
An elastomeric coating with MetaLine 785 seals and protects – for buoys, fenders and other water equipment
Drain coating – on this Australian cruise line ship a principle problem with leaking deck drains became visible. To take out and modifying the construction would have caused a severe disturbance of the leisure life on board. MetaLine 785 did solve the problem on 35 drains during the cruse with a minimum of inconvenience. Just 30 minutes per drain was needed to spray in a new elastomeric MetaLine inliner
Winch coating – rubberlined winch for commercial fishing. The worn rubber was completely removed und replaced by an accurate molding with MetaLine 760
Fender coating – that is the latest technology of high-tec fenders for luxury boats. Equipped with soft foam rollers which are covered with a MetaLine 785 coating, the system eases mooring manoeuvres
MetaLine 795 for repair and coating of leisure craft – the low coefficient of sliding friction serves as a means to avoid slipping on GFRP or PE surfaces
Camouflage coating – elastomeric MetaLine coatings can what rubber can not – to offer seamless rubberlike camouflage properties and to reject sonar detection
Hull coating – skirting boards, foam fenders and other open structured materials receive a much better durability and longlife behaviour with a MetaLine 785 coating
A topcoat of MetaLine 598 protects synthetic hulls against osmosis effects
Antifouling without antifouling – simply a different principle! Instead of reducing the growth by use of toxic substances, MetaLine relies on a permanently cleanable non-stick effect
Hull coating – MetaLine 785 in a thickness of 2 mm protects the hull slightly above and underneath the waterline (dark blue) from rough landings of this smaller ferryboat at the Faroe Islands
Nothing for the small pocket ... as a means of protection against minor damage underneath the water level – but without anti-fouling effects due to environmental reasons
