TEL +49 (0) 7034 31000    |     |    Contacts

 

Select your language

metaline_slide-002_000007473530L_erosionsprobleme-ventilatoren-geblaesen.jpg

We have a solution for
cost problems on pump casings
by means of protective coatings!

Image not available
Image not available

Scope of application:

Centrifugal pumps
Spiral pumps
Vertical inline pumps
Axial horizontal split case pumps
Sewage pumps
Submersible pumps
Seawater pumps
Elbow pumps
Pump volute liner
Volute frame plate liner

Downloads:

KSB Pumps Test Winner

The elastomeric MetaLine coating technology is the great winner of the "KSB Pumps (Germany) coating test".
In comparison with about 25 international competitors, our energy absorbing material process has established itself with an up to 35 (!) times higher wear resistance!

As the only (!) synthetic coating at all, MetaLine has been classified by KSB as "... a functional cavitation protection ..."! The erosion resistance was even rated twice as high as KSB’s special alloy "Noridur"!

More information

Technical solutions in detail

MetaLine Series 700 –

MetaLine Series 700 coatings optimize pump efficiency owing to their elastomeric very smooth, flow-optimized surfaces. Efficiency increases of more than 3 % are even possible with new housings. Service life extension (wear protection optimization) compared to FE materials amounts up to 500 %, compared with NON-ferrous materials (stainless steel) up to 150 %! Basically, the coating serves as a wear layer to protect the original material and especially its static behavior. This wear layer may be renewed if needed for a low cost. However the housing's original strength and geometry remains fully intact. A special form of cost optimization is the repair of pump half-shells made of rubber. Here, with minimal effort, existing change parts can be fully regenerated again. The cost savings compared to new parts procurement are significant.

 

Product details

Please publish modules in offcanvas position.